Rotatable Head Cable Cutter Technical Data: Item No: ECSB-65C Cutting range: Below Φ65 Cu-Al Cable and Armored cable Size: 565*70*182mm Weight: approx. 5.65kg Package: steel case Usage: Cu-Al Cable, Armored cable The main cutting force of the rotatable head cable cutter comes from the blade, which is fixed by two screws and splints. In the […]
Multi-functional Electric Wire Cutter
Item No: EBSE-20/ EBSE-32
Cutting Force: 60KN
Cutting Charge: 130 times
Below Φ32 ACSR, Steel wire ropes
Below Φ15 Prestressed steel wire
Charge time: 2 hours
Package: plastic box
Blade: 1 pc
Battery: 2 pcs
Charge: 1 pc
Sealing ring of cylinder: 1 set
Sealing ring of valve: 1 set
Operation method of Multi-functional Electric Wire Cutter:
When cutting low alloy steel, the high hardness cutter shall be replaced, and the cutting diameter shall meet the requirements of the mechanical nameplate.
When cutting the short material, the distance between the hand and the cutter shall be kept over 150 mm. If the hand grip end is less than 400 mm, the short head of the steel bar shall be pressed or clamped firmly by the sleeve or clamp.
During operation, it is strictly prohibited to directly remove the broken ends and sundries near the cutter by hand. No non operators are allowed to stay around the steel bar swing and cutter.
In case of abnormal operation, abnormal noise or cutter deflection, the machine shall be shut down for maintenance immediately.
After operation, cut off the power supply, use the steel brush to remove the sundries between the cutters, and clean and lubricate the whole machine.
Before the operation of the hydraulic transmission cut-off machine, check and confirm that the hydraulic oil level and the rotation direction of the motor meet the requirements. After start-up, no-load operation shall be carried out, the oil valve shall be loosened and the air in the hydraulic cylinder shall be discharged before the steel cutting.
Before the use of the manual hydraulic cut-off machine, the oil drain valve shall be tightened in a clockwise direction. After the cutting, it shall be immediately loosened in a counterclockwise direction. During operation, the operator shall hold the cutting machine stably and wear insulating gloves.